User Manual Q&AAnswer
Feb 20, 2025 - 11:33 PM
To adjust the speed and timer settings on the Labnet ProBlot Rocker 25 and 25XL, follow these steps:
1. Turn on the rocker by flipping the POWER switch. The power switch will illuminate.
2. Set the desired speed by using the SPEED controller. The speed settings range from 5 to 120 tilts per minute.
3. Set the desired timer duration by using the TIME controller. The timer can be set from 0 to 2 hours or set to continuous operation.
4. Press the START/STOP button to start the rocking motion. The green light labeled "RUN" will illuminate to indicate that the shaker is operating.
5. If you want the rocker to operate continuously without a timer, set the TIME controller to the "HOLD" position. The yellow light labeled "HOLD" will illuminate, indicating continuous operation.
6. To stop the rocking motion, press the START/STOP button. If the timer is set, the device will automatically stop after the set time duration.
Note: Pressing the START/STOP button during timed operation will reset the timer.
Please refer to the Labnet ProBlot Rocker instruction manual for more detailed information and safety precautions.
Add New Comment