User Manual Q&AAnswer
Feb 20, 2025 - 11:31 PM
To switch the Futaba R7308SB receiver to Dual RX Link mode, follow these steps:
1. Turn on the receiver. Make sure the transmitter is turned off.
2. Press and hold the SW (switch) button on the receiver for 5 seconds or more.
3. After restarting, the MODE LED on the receiver will light up, indicating that the receiver is now in Dual RX Link mode.
In Dual RX Link mode, you can install two receivers on your aircraft, allowing one receiver to act as a backup in case the other receiver loses communication. The SB2/RX port on the receiver is used for reception only, so make sure to use the appropriate CH mode (B, C, D, F, G) for S.BUS output and S.BUS2 input/output.
Please refer to the user manual for more detailed instructions and information on using the Dual RX Link mode with the Futaba R7308SB receiver.
Add New Comment