User Manual Q&AAnswer
Feb 20, 2025 - 11:09 PM
To configure the network settings for the HARVEST NCMR Audio Interface, follow these steps:
1. Connect the NCMR device to your LAN via the Ethernet port and power the device.
2. Configure the IPv4 settings of a computer connected to the same network. Set the IP address to 192.168.2.x, subnet mask to 255.255.255.0, and gateway to 192.168.2.1.
3. Open a web browser and navigate to http://192.168.2.1.
4. Login using the following credentials:
- User: admin
- Password: admin
5. Once logged in, you will be directed to the WebUI dashboard.
6. From the dashboard, select the "Configuration" section.
7. In the network configuration section, you can view and modify the Ethernet and WiFi settings.
8. To configure Ethernet settings, select the Ethernet adapter from the dropdown list and enable it. Enter the network settings provided by your Network Administrator and save the changes.
9. To configure WiFi settings, select the WiFi adapter from the dropdown list and enable it. Choose the available network or manually enter the network details. Enter the network settings provided by your Network Administrator and save the changes.
10. After configuring the network settings, ensure that the required ports are open on your network devices for data streaming, device control, and connection management.
11. If you made changes to the Ethernet settings, disconnect and reconnect the Ethernet cable or power cycle the device for the settings to take effect.
12. Your HARVEST NCMR Audio Interface is now configured with the network settings.
Please note that these instructions are a general guideline, and it is recommended to refer to the user manual for specific details and any additional steps that may be required for your specific setup.
Add New Comment