User Manual Q&AAnswer
Feb 20, 2025 - 10:44 PM
To connect the FLEXTHERM CONCERTO Connect thermostat to your heating system, you will need to follow these steps:
1. Ensure that the breakers for your heating system are turned off at the main electrical panel before starting the installation.
2. Unlock and lift the thermostat cover.
3. Connect the heating floor by using the load/line wire connectors located on the back of the thermostat.
4. Connect the ground wire to the xxxx in the electrical box intended for this purpose. Make sure to firmly tighten the wire connectors for a secure connection.
5. Connect the sensor if you are using control applications in F mode or with a floor limit.
6. Use screws to secure the thermostat to the electrical box. Replace the cover and lock it.
7. Power up the thermostat.
8. After performing a test sequence, the thermostat should display the floor temperature. If not, refer to the troubleshooting guide in the manual.
Please note that the installation of this thermostat must be performed by a certified electrician and comply with national and local electrical codes and regulations. For more detailed instructions and safety precautions, please refer to the FLEXTHERM CONCERTO Connect Installation Guide.
Add New Comment