Answer

Feb 20, 2025 - 10:40 PM
To install the SATCO NUVO 0-10V BLINK LED Flush Mount Light, please follow the steps outlined in the instruction manual:
Step 1: Turn off/disconnect power at the circuit breaker. Attach the orange connector provided to the AC cable from the junction box: L side to the Black side wire, and N side to the White AC wire.
Step 2: Attach the bracket to the junction box using the two screws provided. Pull the AC cable with the connector through the bracket center hole.
Step 3: Make the ground and dimming connections using the wire nuts provided. Then, simply "click" the two sides of the orange connector together.
Step 4: Align the slots on the edge of the fixture with the Pressure Clips on the mounting bracket and push to lock the fixture in place.
Step 5: Push and feed all wires up into the junction box as you raise the fixture into place. For wet location usage, please caulk the edge of the fixture with glue to the ceiling.
If you are not familiar with proper wiring connections and building codes, it is recommended to consult a qualified electrician for assistance.
Please note that all electrical connections must be in accordance with local and National Electrical Code standards, as well as local building codes.
For further information or clarification, you can contact SATCO customer service at 1-800-43-SATCO or visit their website at www.satco.com.
Add New Comment