User Manual Q&AAnswer
Feb 20, 2025 - 10:30 PM
To prime the Clarke BPT1200SS Booster Pump, follow these steps:
1. Remove the filler plug on top of the pump.
2. Slowly fill the pump with water until all air is expelled.
3. If the inlet filter is being used, remove the brass plug on top of the filter unit and fill the filter bowl with water.
4. Switch on the pump and check for leaks. Water should start to flow through the system after a short while.
It is important to ensure that all connections and hoses are completely tight to prevent air leaks and ensure proper priming of the pump.
Add New Comment