How do I install the Remote Alpha Loop Kit on my Alpha Loop Antenna? (ALPHA ANTENNA Remote Alpha Loop Kit User Guide)

Answer

manuals.plus

Feb 20, 2025 - 10:25 PM


Installation of the Remote Alpha Loop Kit on your Alpha Loop Antenna involves the following steps:

1. Position the grey Alpha Match box so that the tuning  xxxx  or remote is on top.
2. Loosen the two screws that hold the black  xxxx  already on the box and slide it off the white nylon shaft. If there are no screws, you can pry off the black tuning  xxxx  using two flat head screwdrivers.
3. Remove the lid on the Mount (D) using a flat head screwdriver, then loosen the two hex screws located on the internal Coupler using a hex wrench. Note that you may need to power up the Remote to re-position the internal Coupler for easier access to the hex screws.
4. Remove the silver tripod mounting nut from your loop's X-Wing Backbone and save it for later use.
5. Place the internal Coupler over the white nylon shaft of the capacitor while simultaneously placing the Mount hole over the hole where the silver tripod mounting nut was removed. Reinstall the silver tripod mounting nut to hold the Mount in place.
6. Secure the internal Coupler by tightening the two hex nuts down upon the white nylon shaft.
7. Plug the Power Supply into a wall outlet and then into the Remote.
8. Connect and secure the Cable from the Binding Posts on the Mount at the antenna to the Binding Posts on the Remote.

For more detailed instructions and illustrations, please refer to the ALPHA ANTENNA Remote Alpha Loop Kit User Guide.

Note: The Remote Alpha Loop Kit is not intended for permanent outdoor use.