User Manual Q&AAnswer
Feb 20, 2025 - 10:01 PM
To install the zencontrol ZC-SS Smart Switch, please follow these steps:
1. Ensure safety warnings are adhered to.
2. Optional: Connect the two DALI terminals to the DALI line, following wiring regulations. Remember that DALI is not polarized and should not be connected to any mains voltages.
3. Remove the front plate by inserting a screwdriver (min. 5.5pt) into the receptacle at the bottom of the frame. Twist left and right to release the cover, but do not lever.
4. Cut out the hole and insert the wallbox if applicable.
5. Insert the provided screws into the frame and attach them to the pre-mounted wallbox or c-clip (not included).
6. Latch the cover on top of the frame to clip the base back into the frame, securing it to the wall.
For more detailed information and illustrations, please refer to the "Installation" section in the zencontrol ZC-SS Smart Switch User Manual.
Note: It is important to have the product installed by a licensed electrician, and to turn off and isolate the electrical supply before commencing installation.
Add New Comment