User Manual Q&AAnswer
Feb 20, 2025 - 09:25 PM
To connect the MATEKSYS F405-VTOL Flight Controller to your receiver, you will need to use the appropriate UART port on the flight controller. The UART ports are labeled as Tx1/Rx1, Tx2/Rx2, Tx3/Rx3, Tx4/Rx4, Tx5/Rx5, and Tx6/Rx6.
If you are using an SBUS receiver, you can connect it to the Sbus pad, which is the UART2_RX pin with an inverter for SBUS receiver.
For other types of receivers, you can use any of the available UART ports. Make sure to connect the receiver's signal wire to the corresponding Rx pin on the flight controller and the receiver's ground wire to the GND pin on the flight controller.
Please refer to the product manual for more detailed information and pinout diagrams.
Add New Comment