User Manual Q&AAnswer
Feb 20, 2025 - 06:04 AM
To connect the FLASH F7100323 LED PAR 64 to a DMX controller, you will need a cable with XLR-female to XLR-Male plugs. The DMX connection is performed using the DMX (in/out) interface on the fixture, which is a 3-pin XLR socket. Simply connect one end of the cable to the DMX output of your controller and the other end to the DMX input of the fixture. Make sure to follow the correct wiring configuration, with the signal (-) and signal (+) properly connected.
Additionally, it is important to terminate the DMX signal at the last fixture in the chain. This can be done by soldering a 120Ω resistor between the signal (-) and signal (+) wires and plugging it into the DMX output of the last fixture. This termination ensures proper signal transmission and avoids any potential issues with the DMX communication.
For more detailed instructions and illustrations, please refer to the user manual provided with the FLASH F7100323 LED PAR 64.
Add New Comment