User Manual Q&AAnswer
Feb 20, 2025 - 04:37 AM
To install the EnOcean 2411 radio wall-transmitter with rocker 1 gang / rocker 2 gang, follow these steps:
1. Selecting installation location: Maintain a minimum distance of about 1m between the transmitter and corresponding receiver. Also, keep a minimum distance of approximately 0.5m from electronic devices that emit high-frequency signals.
2. Mounting on a wall box: xxxx the supporting plate onto a wall box in the right position, ensuring that the label "TOP/OBEN" is at the top.
3. Sticking on a smooth, flat surface: If mounting on a smooth, flat surface, remove the surplus backing film and align the adhesive film onto the mounting surface. Press the adhesive film firmly and remove the protective foil. Align the supporting plate onto the adhesive film, with the label "TOP/OBEN" at the top.
4. Mounting the radio module: Place the frame onto the supporting plate, then place the EnOcean radio module onto the supporting plate over the locking spigots. Push the yellow locking pins on the left and right of the radio module under the locking spigots until they stop. Place the rocker onto the radio module and push it on until it engages.
5. Dismantling the device: Push the rocker down and, on the opposite side, reach under the rocker and pull it off. Using a screwdriver, push the yellow locking pins on the left and right of the radio module downwards/upwards to unlock the module. Remove the radio module and frame, and unscrew the supporting plate or release it from the adhesive film.
Please refer to the instruction manual for more detailed instructions and illustrations.
Add New Comment