User Manual Q&AAnswer
Feb 20, 2025 - 03:57 AM
To adjust the spring force on the MIMSAL MIMLED 600 and MIMLED 1000 Stand, follow these steps:
1. Make sure the spring arm is in the top position.
2. Remove the left joint cover on the spring arm by carefully prying it out of the groove with a narrow flat-blade screwdriver.
3. Position the end device in the top position.
4. Insert a flat-blade screwdriver into the hole.
5. Adjust the spring force by rotating the screwdriver to the left (counter-clockwise) if the spring arm lowers or to the right (clockwise) if the spring arm rises.
6. Install and snap the joint cover back into place.
Note: Be careful not to tighten the brake xxxx too much, as it can damage the spring arm. Only tighten the brake xxxx carefully while monitoring the braking force control.
It is recommended to refer to the MIMSAL MIMLED 600, MIMLED 1000 Stand Instruction Manual for more detailed instructions and illustrations.
Add New Comment