Answer

Feb 20, 2025 - 01:05 AM
To install the pushbutton covers on the Eaton IL01301065E Air Circuit Breaker, follow these steps:
Step 1: Install one mounting xxxx into the lower mounting hole on the breaker faceplate using 3-4 turns.
Step 2: Slide the base with installed doors in the open position onto the mounting xxxx installed in Step 1. Slide the doors all the way up to unlock them, then slide the doors all the way down so that the tabs on the doors slide into the groove space on the base for the full open position.
Step 3: Insert the second mounting xxxx through the other mounting hole in the base and into the mounting hole in the faceplate. Torque both mounting screws to 6.0 lbs-in (0.68 Nm). Insert the remaining two mounting screws through the indicated holes in the pushbutton cover and into the mounting holes in the faceplate. Torque both mounting screws to 6.0 lbs-in (0.68 Nm).
Step 4: Once the pushbutton cover assembly is mounted on the breaker faceplate, the doors or individual doors are ready for use.
Step 5: The doors can be closed and padlocked to prevent access to pushbuttons simultaneously or individually. A wire seal can also be used on the doors as required. For all padlock and wire seal holes to match, the doors must be all the way down so that the door tabs are in the groove space on the base.
Step 6: Up to three individual padlocks can be used to prevent the doors from being opened by unauthorized individuals. Remember that padlocks must be removed to open any locked door.
Please refer to Figure 2 and Figure 4 in the instruction manual for visual reference.
Add New Comment