User Manual Q&AAnswer
Feb 20, 2025 - 12:41 AM
To properly fit and install the Grange Side Rails on your bed, please follow the instructions provided in the manual. Here is a step-by-step guide:
1. For the Standard Variant:
- Select two brackets, one offset bracket, and one standard bracket. Note the correct orientation of the arrow and release plungers on the brackets during installation.
- Hook one of the offset brackets onto the appropriate side of the mattress platform at the head end of the bed. Ensure the arrow is pointing upwards when the release plunger is facing away from the headboard.
- Fully tighten the offset bracket hand wheel to secure it to the head end mattress platform side tube.
- Hook one of the standard brackets onto the foot end of the mattress platform. Ensure the arrow is pointing upwards when the release plunger is facing away from the footboard. Do not fully tighten the hand wheel on the standard bracket yet.
- Pull the release plungers on each bracket and slide the side rail into the brackets. Ensure the magnolia half of the side rail is positioned at the head end of the bed.
- Raise the side rail until it latches in the raised position at both the head and foot end. Adjust the length of the side rail as desired.
- Ensure the gaps between the side rail and the bed ends are within the specified limits.
- Fully tighten the foot end bracket hand wheel to secure the side rail in position. Repeat the procedure with the remaining side rail on the other side of the bed.
2. For the Divan Variant:
- Before beginning the assembly process, remove the mattress from the bed base.
- Place the two cross bars onto the base of the bed, ensuring the arrows on each bracket are pointing upwards and the red release plungers are facing inwards towards each other.
- Adjust the cross bar length to suit the width of the bed base by removing the clip, extending the cross bar, and re-inserting the clip into the suitable hole for the bed base width. The metal tabs should hug the sides of the bed base.
- Place the mattress on top of the cross bars.
- Pull the release plungers on each bracket and slide the side rail into the brackets. Ensure the magnolia half of the side rail is positioned at the head end of the bed.
- Raise the side rail until it latches in the raised position at both the head and foot end. Adjust the length of the side rail as desired by repositioning the foot end cross bar down the length of the bed.
- Ensure the gaps between the side rail and the bed ends are within the specified limits.
- Ensure the over-extension label is not visible on the inner section of the side rail.
- Repeat the procedure for the remaining side rail on the other side of the bed.
Please refer to the manual for additional warnings, usage instructions, maintenance guidelines, and warranty information. If you have any further questions or concerns, it is recommended to contact your equipment provider or Drive DeVilbiss Healthcare Ltd. for expert advice.7
Add New Comment