User Manual Q&AAnswer
Feb 20, 2025 - 12:21 AM
To install the Lucci LEDlux Mona Wall Bracket, follow these steps:
1. Ensure that the power to the circuit you are working on has been switched off before starting any electrical work.
2. Remove all packaging material from the product, being careful not to throw away any accessories that may be hidden within the packaging.
3. Loosen the screws to remove the mounting bracket from the lamp body.
4. Use the mounting bracket as a template to mark the xxxx positions on the wall.
5. Install the mounting bracket onto the wall using appropriately sized mounting screws and anchors. Make sure the screws and anchors used are suitable for the mounting surface.
6. Pull the terminal block out from the lamp body hole and connect the mains supply wire. The neutral wire (blue or black) should be connected to the fitting wire (blue), and the live wire (brown or red) should be connected to the fitting wire (brown). Ensure the wires are secure and no bare wires are exposed.
7. Put the terminal block back into the lamp body hole.
8. Attach the lamp body onto the mounting bracket and secure it by inserting the screws through the lamp body hole. Finally, tighten the screws using a screwdriver.
Please note that this is a general guide, and it is important to consult a licensed electrician for proper installation to ensure compliance with local and national wiring rules.
For more detailed instructions and safety tips, please refer to the Lucci LEDlux 300250 Ledlux Mona Wall Bracket Instruction Manual.
Add New Comment