User Manual Q&AAnswer
Feb 19, 2025 - 10:14 PM
The installation process for the Racold ODS Eco + Gas Instantaneous Water Heater is as follows:
1. Choose a suitable location: Select a location for the water heater that is well-ventilated, away from flammable materials, and easily accessible for maintenance.
2. Connect the gas supply: Ensure that the gas supply is turned off before connecting the water heater to the gas line. Use a qualified gas technician to connect the gas supply to the water heater following the manufacturer's instructions.
3. Connect the water supply: Connect the cold water inlet and hot water outlet pipes to the respective connections on the water heater. Use appropriate fittings and ensure that the connections are tight to prevent leaks.
4. Install the flue pipe: Install the flue pipe according to the manufacturer's instructions. The flue pipe is responsible for venting out the combustion gases safely.
5. Connect the electrical supply (if applicable): If your water heater model requires electrical connection, consult a qualified electrician to connect the water heater to the power supply following the electrical requirements mentioned in the user manual.
6. Test for leaks: Once the installation is complete, check all the connections for any gas or water leaks. Use a soap solution to identify any gas leaks, and tighten the connections if necessary. If you detect any water leaks, ensure that the connections are properly sealed.
7. Turn on the gas supply: After ensuring that there are no leaks, turn on the gas supply and check for proper ignition and functioning of the water heater.
Please note that the above steps are a general guideline, and it is recommended to refer to the specific installation instructions provided in the Racold ODS Eco + Gas Instantaneous Water Heater user manual for detailed and accurate installation procedures.
Add New Comment