User Manual Q&AAnswer
Feb 19, 2025 - 09:42 PM
Sure! Here is a step-by-step guide to help you install the INTERMATIC Pool, SPA Control Accessories:
1. Safety Precautions:
- Read and follow all instructions provided in the manual.
- Ensure that the Junction Box is installed by a qualified person, following National and Local Electrical Codes.
- Install the Junction Box at least 48 inches away from the inside edge of the pool.
- Use copper conductors only.
- Do not exceed the maximum ratings of individual components and wiring devices.
- Refer to Article 680 of the National Electrical Code for grounding, bonding, and installation of underwater luminaires.
- Always disconnect electricity before servicing the Pool/Spa equipment.
2. General Information:
- The Junction Box is designed for pools, pool-spa combinations, and landscape applications.
- It can accommodate up to four high or low voltage luminaires.
- It accepts flexible cords from #16-3 up to #12-3 and #10-2 in any combination, and conduits from 1/2 to 1 inch.
- A grounding bar and external bonding lug are provided.
- The Junction Box complies with UL1241 and the National Electric Code.
3. Installation:
- Prepare a wiring layout according to Article 680 of the National Electric Code and applicable local codes.
- Use copper conductors only.
- The Junction Box can accommodate water-resistant flexible cords: #16/3 or #14/3 Extra-hard usage, or #12/3 or #10/2 Hard usage.
- Torque wire to terminal 15-20 lbf-in.
- Rigidly support the Junction Box and permanently plug unused conduit openings with the provided plugs.
- Determine the best location for the Junction Box, ensuring it is at least 4 feet from the inside wall of the pool, 8 inches above the maximum water level, and 4 inches above the deck or grade.
- Cut off all conduits at the same level and use reducer bushings as needed.
- Apply PVC Solvent Cement to secure the conduit and reducer bushing.
- Connect the optional external bonding lug to the Equipotential Bonding Grid if required.
- Pull supply conductors from the source and flexible cord from luminaires into the Junction Box.
- Use twist-on wire connectors or other approved termination methods for power connections.
- Connect ground conductors and bonding conductors (if required) to the ground bar.
- Tighten terminal screws to a minimum of 35 in-lbs.
- Install strain reliefs, ensuring the clamps are positioned correctly based on cable diameter.
- Check tightness of connections, ensure the gasket is properly seated, and close the Junction Box using the provided screws.
4. Troubleshooting:
- If an on light is off, check for a burned-out bulb or a bad connection. Replace the bulb or correct the defect.
- If all lights are off, check for a tripped breaker or an open GFCI. Reset the breaker or call an electrician.
For further assistance or warranty service, you can contact Intermatic Incorporated through their website at www.intermatic.com or by calling 815-675-7000.
Please note that this answer is based on the information provided in the manual for the INTERMATIC Pool, SPA Control Accessories. Always refer to the manual for specific instructions and safety guidelines.
Add New Comment