How do I set up the audio-technica AT-ONE UHF Wireless Microphone System? (audio-technica AT-ONE Wireless Microphone System User Guide)

Answer

manuals.plus

Feb 19, 2025 - 03:42 AM

To set up the audio-technica AT-ONE UHF Wireless Microphone System, follow these steps:

1. Turn on the receiver by pressing and holding the power button.
2. Press and hold the forward or backward button for 1 second to enter the channel selection mode. The channel display will start flashing.
3. Use the forward or backward button to select an interference-free channel. Refer to the frequency chart in the manual for available channels.
4. Once the desired channel is selected, wait for 3 seconds until the flashing stops. The channel is now set.
5. Open the battery cover of the body-pack transmitter and insert the batteries, ensuring correct polarity.
6. Unscrew the battery compartment of the handheld transmitter and insert the batteries, ensuring correct polarity.
7. Adjust the transmitters to the same channel as the receiver. The number on the transmitter corresponds to the frequency group and channel number. For example, '1' represents the first frequency in Group 1.
8. When switching frequencies, turn off the transmitter to avoid pops.
9. To turn on the body-pack or handheld transmitter, press the power button for 4 seconds. Press and hold the power button for 4 seconds to turn it off. Click the power button to mute the transmitter.
10. Once the setup is completed, the receiver will receive the RF signal, and the RF indicator will light up red.

Please refer to the user guide for more detailed instructions and additional information on operating the audio-technica AT-ONE UHF Wireless Microphone System.