User Manual Q&AAnswer
Feb 19, 2025 - 03:31 AM
To activate the PS-M2 Vehicle Power Stabilizer and select the desired output mode, follow these steps:
1. Connect with Power Outlet: Plug the adapter into an AC power outlet.
2. Connect to Vehicle Battery: First, clamp the red positive cable to the intended vehicle's positive battery terminal (marked as "+"). Then, clamp the black negative cable to the intended vehicle's negative battery terminal (marked as "-").
3. Power On but not Activated: The default mode will be MAINTAIN mode. When not activated, the voltage output status is OFF.
4. Activate Power Output: Press the power key on top of the PS-M2. After 3 beeps, the blue LED indicates output action (MAINTAIN mode). The screen shows the voltage (e.g., 12.BV) and current (e.g., 10A) values.
5. Select Output Mode: To select the desired output mode, press the power key again. The available output modes are VOLT1 (15V), VOLT2 (14.4V), VOLT3 (13.8V), and MAINTAIN (12.BV). Each mode is suitable for different battery types. Refer to the manual for more information on battery compatibility.
6. Device in Service: The PS-M2 will continuously provide stable voltage output according to the selected mode. The current value will be actively adjusted based on the vehicle's current consumption.
Please note that if any warning buzzer or lights are activated, refer to the manual for specific troubleshooting instructions.
Add New Comment