User Manual Q&AAnswer
Feb 19, 2025 - 03:09 AM
To wire the EMX ULT-II Vehicle Loop Detector, you will need to connect the 7 pin male connector with xxxx terminal to the appropriate components. Here is the wiring connection for each pin:
1. Loop Connection
2. Loop Connection
3. Power + (12-24 VDC/AC)
4. Power - (12-24 VDC/AC)
5. Relay - NO (normally open contact)
6. Relay - COM (common contact)
7. Relay - NC (normally closed contact)
Make sure to follow the instructions provided by the gate or door operator manufacturer for proper installation.
Source: https://manuals.plus/emx/ult-ii-vehic... xxxx -terminal-manual
Add New Comment