Answer

Feb 19, 2025 - 01:56 AM
To install the Praxis M30 MTB Direct Mount Crankset, follow these steps:
1. Make sure that your Praxis M30 bottom bracket is installed in the frame according to the instructions provided with the bottom bracket.
2. Grease the interface between the Direct Mount Ring and the crank arm.
3. Install the Direct Mount Ring on the drive arm using the three T-25 bolts provided. Torque the bolts to 9Nm.
4. Grease the spindle of the crankset.
5. Slide the Wave Washer onto the spindle.
6. Slide the correct 30mm Dust Cover onto the spindle, making sure to follow the guide provided to ensure the correct orientation. The Praxis logos on the Dust Cover should face the Direct Mount Ring.
7. Insert the crank into the RIGHT/Drive Side Cup of the bottom bracket.
8. Push the crank fully through the bottom bracket.
9. Put the correct 28mm Non-Drive Side Cover onto the spindle, following the guide for the correct orientation. The Praxis logos on the Dust Cover should face outward.
10. Install the LEFT/Non-Drive Side arm using an 8mm hex wrench. Torque the arm bolt to 48-52Nm.
11. Verify that the crank spins freely.
12. The installation is now complete.
Please note that these instructions are a summary and it is recommended to refer to the Praxis M30 MTB Direct Mount Crankset Instruction Manual for detailed step-by-step installation instructions.
Add New Comment