User Manual Q&AAnswer
Feb 19, 2025 - 01:39 AM
To install the cutting line on the Greenworks Pro 2101102VT 80V String Trimmer, please follow these steps:
1. Make sure the trimmer is turned off and the battery is removed for safety.
2. Locate the spool and bump head on the trimmer head.
3. Push and rotate the bump head to align the slots as indicated in the manual.
4. Remove the spool by pressing the tabs on the sides and pulling it out.
5. Cut a length of cutting line (0.080 inches diameter) to the desired length.
6. Insert one end of the cutting line into the hole in the center of the spool.
7. Wind the cutting line around the spool in the direction indicated by the arrow on the spool until only 6-8 inches of line remain.
8. Insert the other end of the cutting line into the slot on the spool.
9. Place the spool back into the bump head, making sure the tabs on the spool align with the slots on the bump head.
10. Press the spool down firmly until it clicks into place.
11. Pull on the cutting lines to ensure they are securely held in the spool.
Please refer to the user guide for visual instructions and additional information.
Add New Comment