User Manual Q&AAnswer
Feb 18, 2025 - 11:54 PM
To adjust the height and width of the Neewer 10094897 Aluminum Alloy Backdrop Cloth Support System, follow these steps:
1. Turn the bottom xxxx of the tripod to loosen it and unfold the three legs of the tripod.
2. Set the tripod legs to the required position and tighten the xxxx to secure.
3. Release the retention latch of the tripod and pull out the extension bar.
4. Adjust the extension bar to the desired height.
5. Press on the latch to secure the extension bar in place.
To adjust the width of the support system, follow these steps:
1. Press in the two metal tabs on the end of crossbar C with your fingers.
2. Insert crossbar C into the end of crossbar A.
3. Rotate crossbar C until the spring-mounted tabs pop out of the holes in crossbar A to lock the position.
4. Install another crossbar C and crossbar B in sequence.
5. Remove the wing nut from the top bolt of the tripod and insert a spacer.
6. Align the bigger hole at one end of crossbar A with the bolt and insert it.
7. Put another spacer and turn the wing nut to secure.
8. Crossbar C can be adjusted according to the width you need.
9. After connecting crossbar C, align the hole at the end of crossbar B with the bolt and insert crossbar B.
10. Turn the wing nut to secure.
Please note that crossbar A and B can only be installed on the stand on both sides, while crossbar C can only be connected in the middle position.
It is important to follow the instructions provided in the manual for safe and proper usage of the backdrop cloth support system.
Add New Comment