User Manual Q&AAnswer
Feb 18, 2025 - 11:40 PM
To connect the BLUSTREAM IP50HD-RX High Definition Video Over IP Receiver to your network, follow these steps:
1. Ensure that you have a 1Gb network switch available for matrix distribution mode. If you are using the one-to-one HDMI extender mode, a network switch is not required.
2. Connect one end of a CAT cable to the LAN RJ45 connector on the IP50HD-RX.
3. Connect the other end of the CAT cable to your network switch or directly to another IP50HD-TX transmitter unit.
4. If your network switch supports Power over Ethernet (PoE), the IP50HD-RX can be powered through the CAT cable. Otherwise, you will need to use the included local 12V 1A power supply.
5. Connect your HDMI display to the HDMI Type A output connector on the IP50HD-RX.
6. If you need to extend audio, connect your audio device to the 3-Pin Phoenix connector labeled "Audio Output."
7. If you need to control devices using RS-232, connect your RS-232 device to the 3-Pin Phoenix connector labeled "RS-232 Serial Port."
8. If you need to use USB or KVM functionality, connect your USB devices to the USB-Type A ports on the IP50HD-RX.
9. If you need to use infrared (IR) control, connect your IR devices to the 3.5mm stereo jack labeled "IR Input" and the 3.5mm mono jack labeled "IR Output."
Please refer to the BLUSTREAM IP50HD-RX High Definition Video Over IP Receiver User Manual for more detailed instructions and troubleshooting information.
Add New Comment