User Manual Q&AAnswer
Feb 18, 2025 - 11:29 PM
To install the PORTOR LIGHTING PT-FLS1 SERIES LED Flood Light, follow these steps:
1. Knuckle Mount:
- Take the fixture out of the package.
- Match the hole of the rubber mat with the bracket and pass the wire through. Fix it with screws.
- Pass the wire through the other bracket and fix it with screws.
- Loosen the screws and adjust the fixture angles as per your requirements. Tighten the screws later.
- For surface mount installation, pass the rubber wire through the mounting head of the bracket and secure it with an inner hexagon xxxx .
2. U-Bracket Mount:
- Take the fixture out of the package.
- Tighten the brackets and screws.
- Loosen the screws and adjust the fixture angles as per your requirements. Tighten the screws later.
3. Slipfitter Mount (only for 105W and 140W):
- Take the fixture out of the package.
- Tighten the brackets and screws.
- Pass the rubber wire through the mounting head of the bracket and secure it with an inner hexagon xxxx .
- Run the rubber wire through the other holder and tighten it with the hexagon socket xxxx .
- Loosen the screws and adjust the fixture angles as per your requirements. Tighten the screws later.
Please note that these instructions are a summary and it is important to refer to the complete instruction manual provided by PORTOR LIGHTING for detailed installation steps. Additionally, it is recommended to have the installation performed by a qualified licensed electrician to ensure safety and compliance with electrical codes.
Add New Comment