How do I install the Tala Sphere IV E26 Alumina Table Lamp? (tala Sphere IV E26 Alumina Table Lamp Instruction Manual)

Answer

manuals.plus

Feb 18, 2025 - 10:49 PM

To install the Tala Sphere IV E26 Alumina Table Lamp, please follow these steps:

1. For table configuration:
- Insert the bulb into the top of the lamp, rotating clockwise until tight.
- Plug the lamp into your chosen wall socket.
- Rotate the dial on the dimmer until the bulb lights up, and adjust the dimmer for your desired light output.

2. For wall configuration:
- Remove the bulb from the lamp by rotating it counter clockwise and set it aside.
- Remove the small lock xxxx from the side of the lamp using the hex key provided.
- Slide the lamp towards the cable to disconnect it from the base and lift the lamp aside.
- Attach the base to your wall using appropriate screws and plugs.
- Move the cable from the top to the bottom opening of the base.
- Align the lamp above the base and slide it down to lock it in place.
- Insert the bulb into the front of the lamp, rotating clockwise until tight.
- Re-attach the lock xxxx using the hex tool provided.
- Plug the lamp into your chosen wall socket, ensuring the power is switched off.
- Switch the power on and rotate the dial on the dimmer until the bulb lights up, then adjust the dimmer for your desired light output.

Please note that if you wish to hardwire the lamp into the household mains, it is recommended to consult a qualified electrician. The product comes with a two-year warranty, and if there are any functional defects during this time, you can contact Tala's customer service team at customerservice@tala.co.uk.