How do I pair the Bluetooth remote with my smartphone using the Celestron 81038 NexGO DX Smartphone Adapter Kit? (Celestron 81038 NexGO Adapter Kit Instruction Guide)

Answer

manuals.plus

Feb 18, 2025 - 10:36 PM

To pair the Bluetooth remote with your smartphone using the Celestron 81038 NexGO DX Smartphone Adapter Kit, please follow these steps:

1. Insert or replace the battery in the remote: Place your thumb in the center of the back cover, press inward, and slide downward to remove the battery door. Insert the CR2032 battery with the positive (+) side facing upward. Replace the cover.

2. Activate pairing mode on the remote: Press and hold the button on the remote for 5 seconds. A blue light will turn on and, after a few seconds, start blinking. This indicates that the remote is now in pairing mode.

3. Pair the remote with your smartphone: Open the Bluetooth settings on your phone and search for available devices. Look for a device called "GBshutter" and select it to pair with your phone.

4. Use the remote with your camera app: Open your camera app on your smartphone. Press the button on the remote to trigger the shutter and take a photo. If your camera is in video mode, you can press the button once to start recording and press again to stop recording.

Please note the following safety instructions for the battery:

- Only use the included CR2032 battery and insert it correctly with the positive side facing upward.
- Do not use a damaged battery.
- Avoid extreme cold or hot locations for the battery to prevent shortened battery life.
- Dispose of the battery according to local regulations and do not put it in the fire.

For further information and troubleshooting, please refer to the instruction manual provided with the Celestron 81038 NexGO DX Smartphone Adapter Kit