How do I set up the PreSonus NSB-series AVB Network Stagebox? (PreSonus NSB-series AVB Network Stagebox User Guide)

Answer

manuals.plus

Feb 18, 2025 - 10:23 PM

To set up the PreSonus NSB-series AVB Network Stagebox, please follow these step-by-step instructions:

1. Connect the stagebox to your AVB network:
- Ensure that your AVB network is properly set up and functioning.
- Connect an Ethernet cable from the stagebox's AVB Ethernet port to your AVB network switch.

2. Connect the stagebox to your audio system:
- Connect the stagebox's analog audio outputs to your audio system's inputs using XLR cables.
- Connect the stagebox's analog audio inputs to your audio system's outputs using XLR cables, if needed.

3. Power on the stagebox:
- Connect the included power cable to the stagebox's power input.
- Plug the other end of the power cable into a power outlet.

4. Configure the stagebox:
- Launch the PreSonus UC Surface software on your computer or mobile device.
- Ensure that your computer or mobile device is connected to the same AVB network as the stagebox.
- In the UC Surface software, select the stagebox from the list of available devices.
- Follow the on-screen instructions to configure the stagebox's settings, such as sample rate, clock source, and channel routing.

5. Test the stagebox:
- Connect audio sources to the stagebox's inputs and audio outputs to your audio system.
- Use the UC Surface software to route the audio signals from the inputs to the outputs.
- Verify that you are receiving audio signal at the desired outputs and adjust levels as necessary.

Please note that these instructions are a general guide, and it's important to refer to the specific details and recommendations provided in the PreSonus NSB-series AVB Network Stagebox Owner's Manual for a more comprehensive understanding of the setup process.