User Manual Q&AAnswer
Feb 18, 2025 - 09:40 PM
To mount the RAB T34 FA 1X4 Field-Adjustable Panel in a recessed ceiling, follow these steps:
1. Firmly bend the pre-installed Grid Clips up and out.
2. Rotate and slide the Fixture as required to fit through the Tee-Grid Bar and place it as indicated by the directional arrow. Secure the Fixture to the Tee-Grid Bar.
3. Support Wires are required by installation codes. Support the Fixture to the building structure with Support Wires through the Grid Clip Hole.
4. Make sure that the orientation of the Splice Box and Access Plate faces an accessible tile to make electrical splices.
5. Loosen Access Plate xxxx and remove the Access Plate. Knock out appropriate Conduit Knockouts on the Access Plate to route input conduit. Use appropriate conduit connectors as required by code.
6. Connect wires as shown in the wiring diagram. Push all wires back into the Splice Box. Use appropriate UL-approved wire connectors as required by code to complete wiring. Be careful not to pinch wires.
7. Replace Access Plate and tighten Access Plate xxxx .
Please refer to the provided manual for visual illustrations and additional safety instructions.
Add New Comment