How do I install and set up the kvm-tec KT-6035 Eco Smart Extender over IP? (kvm-tec KT-6035 Eco Smart Extender Over IP Installation Guide)

Answer

manuals.plus

Feb 18, 2025 - 09:04 PM

Installation and setup of the kvm-tec KT-6035 Eco Smart Extender over IP is a straightforward process. Here are the steps to follow:

1. Connect the CPU/Local Unit: Start by connecting the CPU/Local Unit to the included 12V 2A power supply.

2. Connect USB Cable: Next, connect the USB cable to a USB socket on your PC and the other end to the CPU/Local Unit.

3. Connect Network Cable: Use a CAT5e/6/7 network cable to connect the CPU/Local Unit and the CON remote.

4. Connect DVI Cable: Connect the DVI cable from the DVI socket of your PC to the DVI socket of the CPU/Local Unit (PC-in).

5. Power On: Ensure that the extenders, monitors, and computer are switched on.

6. Accessing the Main Menu: Press the ALT+GR key on your keyboard quickly five times to access the main menu.

7. Using the Main Menu: The main menu provides an overview of sub-menus. Press the applicable key to open a sub-menu.

8. System Status: In the status overview menu, you can view the current status of the extender connection, including video resolution and USB status.

9. Firmware Version: Under the "A" menu, you can view the currently installed firmware version of the remote (CON) and local (CPU) Extender.

10. Features Menu: The features menu allows you to enable or disable various settings, such as Point to Point mode, Matrix Switching mode, USB emulation mode, and more.

11. Point to Point Mode: Press the "P" key to switch the Point to Point mode on or off. Note that activating this mode will disable the switching mode.

12. Matrix Switching Mode: Press the "M" key to toggle the Matrix Switching mode on or off.

For further assistance or detailed instructions, you can refer to the kvm-tec KT-6035 Eco Smart Extender over IP Installation Guide available for download on the kvm-tec website or contact their support team via email or phone.