User Manual Q&AAnswer
Feb 18, 2025 - 08:48 PM
To set up the HT500 SET Smart Room Thermostat, please follow these steps:
1. Shut down the electrical current connected to your boiler.
2. Connect one of the boiler connection cables to the HT500 SET receiver according to the provided Connection Scheme.
3. Connect the other end of the boiler connection cable to the boiler's room thermostat input, as specified in the boiler's user manual.
4. Connect the Receiver Power Cable to the receiver and plug it in. If there is no plug near your boiler, you can connect the cable to your boiler's connection fuse.
5. After completing the connections, turn on the electrical current first, and then turn on your boiler.
6. Press the manual usage button on the receiver for 2 seconds. You should see an orange light blinking. Once your boiler is confirmed to be working, press the same button for 2 seconds again to turn off the orange light.
7. Set up your Room Thermostat to sync with the receiver.
Note: It is recommended that only persons with professional competence perform electrical wiring or boiler setup operations.
For more detailed instructions and illustrations, please refer to the "HT500 SET RECEIVER SETUP" section in the user manual.
Add New Comment