User Manual Q&AAnswer
Feb 18, 2025 - 05:44 AM
To install the INVIXIUM MERGE 2 MERGE CR device, follow these steps:
1. Remove the Mounting Plate, Wired Back Cover, and Screws from the IXM INSTALL KIT.
2. Install the Mounting Plate at the desired location, recommended to be 120 cms from the floor to the bottom of the device.
3. Make the necessary connections to the Wired Back Cover by referring to the "Get Wired" section in the user guide.
4. Unscrew and remove the Temporary Back Cover from the device and connect the Wired Back Cover using the same screws.
5. Hang the device on the Mounting Plate and secure it on the bottom with the provided xxxx .
For more detailed instructions and illustrations, please refer to the Invixium Installation Guide.
Note: It is important to connect the device to a high-quality Earth Ground for protection against Electrostatic Discharge. Follow the instructions in the "Get Wired Glossary" section to connect to Earth Ground properly.
If you encounter any issues during installation, please contact your Local Authorized Reseller or visit the Invixium Customer Portal for further support and resources.
Add New Comment