How do I mount the RAB LES2X13 Leslie LED Dual Head Flood Light? (RAB LES2X13 Leslie LED Dual Head Flood Light Instructions Manual)

Answer

manuals.plus

Feb 18, 2025 - 05:21 AM


To mount the RAB LES2X13 Leslie LED Dual Head Flood Light, follow these steps:

1. Apply weatherproof silicone sealant around the edge of the Junction Box (not supplied), especially if the wall surface is uneven.
2. Attach the Universal Mounting Bar to the Junction Box using the screws provided. If you have a surface mount junction box, use it with the Metal Surface Plate.
3. Use the 'S' shaped hands-free Hanging Hook to hold the CU4 plate during wiring.
4. Bring the power leads and LESLIE13 head leads into the Junction Box.
5. Strip off at least 1/2" of insulation from all leads and insert them through the openings in the Metal Surface Plate (if used).
6. Attach the ground wire to the grounding  xxxx  on the Junction Box. Complete the wiring as shown in the wiring diagram section.
7. Align the Gasket, CU4 Plate, and Metal Surface Plate (if used) to ensure a proper seal.
8. Tighten the Center  xxxx  (make sure the O-Ring Gasket is on the  xxxx ) to attach the CU4 plate to the box. Check that the Gasket is fully sealed.
9. Insert the plastic Finishing Cap in the center of the CU4 plate for a weatherproof seal. Use silicone sealant on all plugs and unused conduit entries.
10. Aim the LESLIE13 heads in the desired direction and tighten the locknut and arm  xxxx .

Please note that these instructions are a summary, and it is important to refer to the full manual for complete details and any variations in equipment or installation situations.