User Manual Q&AAnswer
Feb 18, 2025 - 05:03 AM
To bind your transmitter to the E-flite Habu SS 70mm EDF Jet, follow these steps:
1. Ensure that your transmitter is turned off and that the throttle stick is in the lowest position.
2. Connect the flight battery to the ESC.
3. The receiver's LED will start flashing rapidly, indicating that it is in bind mode.
4. Turn on your transmitter while holding down the bind button or switch.
5. The receiver's LED will stop flashing and remain solid, indicating a successful bind.
6. Verify that all control surfaces on the aircraft respond correctly to your transmitter inputs.
Note: If the receiver loses communication with the transmitter during flight, the failsafe will activate, moving the throttle to low and stabilizing the pitch and roll channels in a descending turn.
For more detailed instructions and troubleshooting tips, refer to the "General Binding Tips and Failsafe" section of the instruction manual.
Add New Comment