User Manual Q&AAnswer
Feb 18, 2025 - 03:00 AM
To install the Red Rubber Fibre Reel Arm Donut on the F.I.G. Fibre Installation Gun, please follow the steps below:
1. Ensure that the F.I.G. Fibre Installation Gun is turned off and disconnected from any power source.
2. Locate the existing reel arm on the gun. This is the part that holds the fibre reel in place.
3. Carefully remove the existing reel arm by unscrewing any screws or bolts that are holding it in place. Keep these screws or bolts in a safe place, as you may need them later.
4. Take the Red Rubber Fibre Reel Arm Donut and align it with the mounting holes on the F.I.G. Fibre Installation Gun. Make sure that the donut is positioned correctly and securely.
5. Insert the screws or bolts that were removed in step 3 through the mounting holes on the donut and into the corresponding holes on the gun. Tighten them securely using a screwdriver or wrench.
6. Once the donut is securely attached, double-check that it is aligned properly and tightened securely.
7. Reconnect the F.I.G. Fibre Installation Gun to the power source and turn it on.
Please refer to the owner's manual for any additional information or specific instructions related to the installation process. If you encounter any difficulties or have further questions, feel free to contact the manufacturer's customer support using the provided contact details.
Add New Comment