How do I perform an insulation test using the Kewtech KT66EV Installation Tester with EVSE Charger Test Adapter? (Mills Kewtech KT66EV Charger Test Adapter Owner's Manual)

Answer

manuals.plus

Feb 18, 2025 - 02:38 AM

To perform an insulation test using the Kewtech KT66EV Multifunction Installation Tester with EVSE Charger Test Adapter, please follow the steps below:

1. Ensure that the tester is properly connected to the circuit or equipment you want to test.

2. Turn on the tester and select the insulation test function. This can usually be done by rotating the dial or using the function keys on the tester.

3. Set the test voltage for the insulation test. The tester should have options for different test voltages. Select the appropriate voltage for your test.

4. Connect the test leads to the circuit or equipment. The red lead should be connected to the live or phase conductor, and the black lead should be connected to the neutral or earth conductor.

5. Press the test button on the tester to start the insulation test. The tester will apply the selected test voltage to the circuit or equipment and measure the insulation resistance.

6. Wait for the test to complete. The tester will display the insulation resistance value on the screen.

7. Compare the measured insulation resistance value with the required or acceptable value for the specific circuit or equipment. Consult the relevant standards or regulations to determine the acceptable insulation resistance value.

8. Record the test result and any relevant information for future reference.

Please note that the exact steps and procedures may vary slightly depending on the specific model of the Kewtech KT66EV Multifunction Installation Tester with EVSE Charger Test Adapter. For detailed instructions and safety precautions, refer to the instruction manual provided with the product.