How do I install the SDC JACKSON Push Pad Non-Handed Rim Panic Exit Device? (SDC JACKSON Push Pad Non-Handed Rim Panic Exit Device Instruction Manual)

Answer

manuals.plus

Feb 18, 2025 - 12:25 AM

The installation process for the SDC JACKSON 1295 Push Pad Non-Handed Rim Panic Exit Device is outlined in the instruction manual provided. Here is a step-by-step guide to help you with the installation:

1. Determine the appropriate location for the panic exit device on the door. Ensure that it meets local building codes and regulations.

2. Prepare the door by drilling holes for the mounting screws and the push pad assembly. Refer to the manual for the specific dimensions and hole locations.

3. Attach the push pad assembly to the door using the provided screws. Make sure it is securely fastened.

4. Install the panic exit device onto the door by aligning the mounting holes with the holes drilled in step 2. Insert the mounting screws and tighten them securely.

5. Connect the necessary wiring for the desired functionality of the device. This may include wiring for remote latch status monitoring, access control REX, magnetic lock release, or mantrap logic. Refer to the manual for detailed wiring diagrams and instructions.

6. Test the functionality of the panic exit device by depressing the push pad and ensuring that the latch retracts properly. Verify that any connected access control systems or magnetic locks operate as intended.

Please note that this is a general overview of the installation process. It is essential to refer to the specific instructions provided in the SDC JACKSON 1295 Push Pad Non-Handed Rim Panic Exit Device Instruction Manual for accurate and detailed guidance.