Answer

Feb 18, 2025 - 12:12 AM
To wire and install the LUTRON HRST-HN Sunnata RF Hybrid Keypad, please follow these steps:
1. Turn off the power at the circuit breaker before installing to avoid electric shock hazard.
2. Determine the load type and derating requirements for your specific installation. Refer to the Load Type table in the instruction manual to determine the minimum and maximum load for your specific load type.
3. Ensure that a neutral wire is available for all load types.
4. If no grounding means exists within the wall box, you can install the dimmer without a grounding connection as long as a plastic, noncombustible wallplate is used. Twist a wire connector onto the green ground wire or remove the green ground wire on the dimmer and use an appropriate wallplate.
5. Protect the keypad from dust and dirt when painting or spackling the wall.
6. Mount the wallplate adapter onto the wall box.
7. Mount the keypad onto the wallplate adapter and attach the wallplate.
8. Turn on the power at the circuit breaker.
For more detailed instructions and information on system setup, phase selection, and troubleshooting, please refer to the complete instruction manual provided with the LUTRON HRST-HN Sunnata RF Hybrid Keypad.
Add New Comment