How do I install the RADEMACHER Comfort RolloTube Automation Set? (RADEMACHER comfort RolloTube Automation Set Instruction Manual)

Answer

manuals.plus

Feb 17, 2025 - 11:59 PM

To install the RADEMACHER Comfort 2360 20 80 RolloTube Automation Set, follow these steps:

1. Start by removing the old roller shutter mechanism. Open the roller shutter box and close the roller shutter completely. Release the roller shutter casing from the winding shaft and remove the existing belt winder and winding belt. Close the belt inlet opening in the roller shutter box.

2. Install the new bearings in accordance with the previous position marks of the old bearings. Make sure that the winding shaft can be installed horizontally and that the first slat of the wound roller shutter casing is perpendicular to the guide rail of the window. Fasten the bearings according to the bearing type and on-site conditions.

3. Determine the length of the winding shaft. The length of the winding shaft is calculated as L = A - (B + C), where A is the window width and B and C are the dimensions of the telescopic shaft. For window widths ranging from 105 cm to 185 cm, you can pull out the telescopic shaft from the octagonal winding shaft up to the required length. If the window is narrower than the winding shaft, you will need to shorten it to the required size using a hacksaw.

4. Slide the tubular motor into the winding shaft, ensuring that the adapter does not slip off the adapter ring on the drive head during the installation process.

5. Install the tubular motor in the bearings. Press the drive head into the click drive bearing and press the counter bearing onto the other side of the telescopic shaft with the fitted ball bearing from above. Finally, fix both winding shafts with the enclosed flat-head screws.

6. Mount the roller shutter casing by sliding the ties or rigid shaft connectors onto the uppermost slat of the roller shutter casing. Place a tie or rigid shaft connector every 40 cm into the rectangular holes of the winding shaft and the telescopic shaft.

7. Follow the electrical commissioning/settings instructions provided in the enclosed operating manual for the tubular motor.

Please note that these instructions are a summary and should be followed in conjunction with the detailed instructions provided in the instruction manual for the RADEMACHER Comfort 2360 20 80 RolloTube Automation Set.