How do I install the ILUMINAR 630W iLogic8 UV + Far Red fixture? (ILUMINAR 630W iLogic8 UV + Far Red User Manual)

Answer

manuals.plus

Feb 17, 2025 - 11:55 PM


To install the ILUMINAR 630W iLogic8 UV + Far Red fixture, follow these steps:

1. Lay the central mast on a flat surface with the attachment brackets facing up.
2. Attach each LED bar by aligning the plastic clips and sliding them into place until you hear a soft click.
3. Connect the A/C cables coming from the mast to each LED bar by aligning the connector pins and pressing the ends together. Lock by twisting in opposite directions.
4. Once all the LED bars are fastened and the A/C cables are attached, turn the fixture over, ensuring the flat surface is clear of anything that could damage the diodes.
5. To suspend mount, attach the four rope ratchets included with the fixture to the LED.
6. Lift the LED and attach the carabiners to pre-installed hooks from the ceiling or mounting beam. The ratchets should be installed closest to the LED (not the ceiling).
7. Adjust the slack in the ropes to raise or lower the fixture as needed.
8. Once the fixture is hanging with all LED bars installed, connect the power cable from the outlet to one side of the fixture.
9. If you plan to daisy chain multiple fixtures, consult the manual for instructions on cable logic connections.

Please note that it is important to read the entire user manual thoroughly before installing or operating the fixture. If you have any further questions or need assistance, you can contact ILUMINAR Lighting technicians for support.