Answer

Feb 17, 2025 - 11:29 PM
To connect the Wizfi360-EVB-Pico Wifi Development Board to your Raspberry Pi Pico, you will need to follow these steps:
1. Make sure you have the necessary hardware: Raspberry Pi Pico and the Wizfi360-EVB-Pico Wifi Development Board.
2. Locate the pinouts on both the Raspberry Pi Pico and the Wizfi360-EVB-Pico board. The pinouts for the Raspberry Pi Pico can be found in its official documentation, and the pinouts for the Wizfi360-EVB-Pico board should be provided in the user manual.
3. Identify the corresponding pins on both boards for the necessary connections. Typically, you will need to connect the following pins:
- GND (Ground) pin on the Raspberry Pi Pico to the GND pin on the Wizfi360-EVB-Pico board.
- 3V3 (3.3V) pin on the Raspberry Pi Pico to the VCC (Power) pin on the Wizfi360-EVB-Pico board.
- GPIO pins on the Raspberry Pi Pico to the respective GPIO pins on the Wizfi360-EVB-Pico board for communication.
4. Use jumper wires or any other suitable connectors to establish the connections between the identified pins on both boards.
5. Once the connections are made, you can start programming and using the Wizfi360-EVB-Pico Wifi Development Board with your Raspberry Pi Pico. Refer to the user manual for specific instructions on programming and utilizing the features of the board.
Please consult the Wizfi360-EVB-Pico Wifi Development Board user manual for detailed pinout information and any additional instructions specific to your setup.
Add New Comment