User Manual Q&AAnswer
Feb 17, 2025 - 10:37 PM
To connect the mXion SWD-ED Powerful Single Servo Decoder to a servo, follow these steps:
1. Locate the servo connector on the decoder. It is labeled as "Connectors single decoder with servo."
2. Plug the servo into the connector on the decoder. The servo should have three wires: red, brown or black, and signal wire.
3. Connect the red wire from the servo to the +5V terminal on the decoder.
4. Connect the brown or black wire from the servo to the GND terminal on the decoder.
5. The signal wire from the servo should be connected to the signal terminal on the decoder.
Make sure to double-check the color coding of the servo wires and match them correctly to the corresponding terminals on the decoder.
Add New Comment