User Manual Q&AAnswer
Feb 17, 2025 - 10:36 PM
To connect the mXion SWD 6 Outputs for Signal Lamps to your track or switch table, follow these steps:
1. Connect the cable from the SWD to the track or switch table. The function output is located between the A1 and +24V terminals.
2. Optionally, you can plug the SWD PLUG into an LGB® EPL® engine. When using the heart piece polarization, the flashing function of the A1 output is automatically deactivated. You will need a 24V relay with changeover contacts and a diode. Connect the diode with the line side to +24V and the other side to A1. Connect the relay between +24V and A1.
3. If you are using the SWD with LGB® signals, there is a modified version available for wing signals. This version allows for a simple exchange of the EPL components. Unscrew the lid of the LGB® drive and xxxx on the SWD-PLUG. Then exchange the LGB® drive with the SWD-PLUG.
Please refer to the manual for more detailed instructions and diagrams on how to connect the mXion SWD 6 Outputs for Signal Lamps.
Add New Comment