How do I adjust the darkness of my waffles using the Sage SWM520 No Mess Waffle Maker? (Sage The No Mess Waffle Maker User Guide)

Answer

manuals.plus

Feb 17, 2025 - 10:26 PM


To adjust the darkness of your waffles, follow these steps:

1. Turn the POWER | DARKNESS Control Dial clockwise to the desired setting to start pre-heating the waffle maker. The POWER light will be illuminated.
2. Use the POWER | DARKNESS control dial to adjust the brownness of your waffle. There are 7 darkness settings ranging from 1 (lightest) to MAX (darkest). Rotate the dial clockwise to increase the brownness or counterclockwise to decrease it.
3. Once the waffle maker has completed preheating, three audible alerts will sound and the READY light will illuminate.
4. Open the lid and pour approximately 125ml of batter evenly on the center of the waffle plate. The batter should cover the peaks of the waffle plate.
5. Close the lid but keep the locking latch open. As the cooking cycle progresses, the READY light will switch off.
6. At the end of the cooking cycle, three audible alerts will sound and the READY light will illuminate. Open the lid and carefully remove your waffles.
7. If your waffles are not at your desired darkness, close the lid and cook for an additional minute.
8. For the most consistent results, add the next batch of batter immediately after removing the cooked waffle and repeat steps 4 through 7.

Note: If the next batch of batter is not added immediately after removing the cooked waffle, close the lid and allow the waffle maker to properly reheat (the READY light will switch off and then back on) before adding batter.