User Manual Q&AAnswer
Feb 17, 2025 - 10:21 PM
To install the WiseNeT ANE-L Series 2MP Turret Camera, please follow these steps:
1. Choose the location: Select a suitable location for the camera installation. Ensure that the area can support the weight of the camera and is protected from direct sunlight, extreme temperatures, and conductive materials.
2. Prepare the camera: Disassemble the camera by rotating the groove of the base anticlockwise and removing the middle cover.
3. Drill holes: Use the provided template to mark the locations for drilling holes. Set the template with the "< >" mark facing the desired monitoring direction. Drill holes according to the template.
4. Connect the camera: Connect the camera's internal terminal with the corresponding cable.
5. Fix the camera: Use two tapping screws to securely fix the camera to the drilled holes.
6. Remove protective films: Remove all protective films from the camera windows.
7. Adjust the monitoring direction: Adjust the pan, rotation, and tilt angles of the camera to the desired monitoring direction. Refer to the user manual for detailed instructions on adjusting the monitoring direction.
8. Reassemble the camera: Put the middle cover back in place and rotate it clockwise until it is firmly locked. Ensure that the insert mark on the camera body aligns with the interlock mark on the middle cover.
9. Connect the PoE cable: Connect the PoE cable to the camera's PoE connector. Ensure that the cable is properly waterproofed if the camera is installed outdoors.
10. Power on and configure: Connect the camera to a power source and configure the network settings according to your network configuration. You can use the Device Manager program to change the IP address and other network settings.
Please refer to the WiseNeT ANE-L Series 2MP Turret Camera User Manual for more detailed instructions and illustrations.
Add New Comment