User Manual Q&AAnswer
Feb 17, 2025 - 09:58 PM
To install the PARMCO DDC800BI 800mm Down Cooktop Induction, follow these steps:
1. Make sure you have a flat surface with a thickness of 30-40mm to install the cooktop on.
2. Ensure that the cupboard underneath the top has enough space to accommodate the inlet plenum, blower cavity, inlet pipe, outlet pipe, and provide good ventilation and heat dissipation.
3. If you are installing the cooktop in extraction mode, make a square opening on the table surface with the size of 765*490mm. Carefully remove any shavings or sawdust before inserting the appliance. Make sure the table surface is level and square and that no part interferes with the installation space.
4. If you are installing the cooktop in recirculation mode, make a square opening on the table surface with the size of 765*490mm. Also, make a square hole from the side of the cupboard with a diameter of about 240*100mm. Carefully remove any shavings or sawdust before inserting the appliance. Make sure the table surface is level and square and that no part interferes with the installation space.
5. Dismantle the package and take out the instruction manual.
6. Place a towel or cloth on the table surface and place the glass face down on the protected surface.
7. Apply the sealing strip to the edge of the bottom of the hob, leaving about 3mm from the edge of the glass. Apply the seal all around the circumference. Cut off the excess part and link the two ends of the sealing strip.
8. Clean the surface of the motor air outlet with a cloth and stick the sealing strip around the air outlet. Cut off the excess part and link the two ends of the sealing strip.
9. For extraction mode, open a hole with a size of about 160mm in the wall in the direction of the air outlet. Put the right-angle elbow on the air outlet and then put the square pipe into the right-angle elbow.
10. Tilt the hob into the cupboard at a certain angle. Put the square to round adapter on the square pipe and put the outer exhaust pipe on the square to round adapter.
11. For recirculation mode, open a hole with a size of about 240*100mm on the side of the cupboard in the direction of the air outlet. Put the right-angle elbow on the air outlet and then put the square pipe into the right-angle elbow.
12. Install the aluminum filter and the air inlet net.
13. Connect the power supply cable according to the wiring diagram in the manual.
14. The installation is now complete.
Please note that these are general installation instructions. For specific details and safety precautions, refer to the PARMCO DDC800BI 800mm Down Cooktop Induction Instruction Manual.
Add New Comment