User Manual Q&AAnswer
Feb 17, 2025 - 09:23 PM
To set the DIP switches on the ELECTRO DEPOT 94334 Series 433 MHz Wireless Control 4 Channel System, follow these steps:
1. Locate the DIP switches on both the transmitter (TX) and receiver (RX) units.
2. By default, the factory setting for the DIP switches is 1234 ON.
3. To match the transmitter to the receiver, set the DIP switches 1 to 4 on both the TX and RX units to the same position. For example, if you want to match the TX and RX units, set all the DIP switches to the ON position.
4. Make sure the DIP switches are set correctly on both the TX and RX units before proceeding with the installation.
Note: The DIP switches are used to establish a unique communication channel between the transmitter and receiver. It is important to ensure that the DIP switches are set the same on both units for proper operation.
For more detailed instructions and illustrations, refer to the user manual provided with the ELECTRO DEPOT 94334 Series 433 MHz Wireless Control 4 Channel System.
Add New Comment