User Manual Q&AAnswer
Feb 17, 2025 - 09:09 PM
To install the WINNERCOM ON PE NFC Touch Door Handle, please follow these steps:
1. Before powering on the device, ensure that you mount the Door handle Module to avoid circuit damage.
2. Check the power supply. The Module Input Power connects to the connector as shown in Figure 1 of the manual.
3. Connect the wires according to the pin configuration mentioned in the manual:
- V Bat (+Vcc): Connect the power supply wire (RED) to the battery positive (+) terminal.
- L_CAN (L): Connect the CAN Low Signal wire (GREEN) to the appropriate CAN bus connection.
- TOUCH_1: This wire (GRAY) is used for the lock function.
- TOUCH_2: This wire (PINK) is used for the unlock function.
- L_CAN (H): Connect the CAN High Signal wire (BLUE) to the appropriate CAN bus connection.
- GND: Connect the Electric Ground wire (BLACK) to the vehicle's ground.
4. Once all the connections are made, you can power on the device.
Please note that it is essential to follow the instructions provided in the manual for proper installation and to avoid any damage to the device.
Add New Comment