User Manual Q&AAnswer
Feb 17, 2025 - 09:03 PM
To connect the gofanco HDExt70 1080p HDMI CAT Extender with Loopout 70m, please follow these steps:
1. Power off all devices including your HDMI source and HDMI display(s).
2. Connect your HDMI source device to the Transmitter's HDMI In connector with an HDMI cable.
3. Optional: Connect a HDMI display to the Transmitter's HDMI Out connector with an HDMI cable for local monitoring of the HDMI signal.
4. Optional: Connect the IR Blaster cable and IR Receiver cable. Face the IR eye towards your device's IR window. This connection is needed only if you need to control your HDMI device from the remote location.
5. Plug your CAT cable between the Transmitter's RJ45 Out and Receiver's RJ45 In.
6. Connect your HDMI display to the Receiver's HDMI Out connector with a HDMI cable.
7. Plug the included power adapters into the Transmitter's and Receiver's power jacks, then plug both power adapters into a reliable power source.
8. Power on all connected devices.
9. The HDMI extender is now ready for use.
For a visual representation of the connections, please refer to the Connection Diagram on page 12 of the User Guide.
Note: Make sure to follow the safety instructions and wiring standards mentioned in the User Guide for optimal performance and compatibility.
Add New Comment