User Manual Q&AAnswer
Feb 17, 2025 - 06:18 AM
To assemble the Mistral MDB-30F09 75cm Commercial Mist Fan, please follow these steps:
1. Assembling the cart:
- Attach the rear wheels to the cart by inserting plastic washers and axles onto the round tube on either side of the cart. Position the wheels on the axles and secure them with M12 washers and nuts.
- Attach 2 casters to the front of the cart using M6 screws for each caster. Tighten the screws to secure.
2. Install the fan head mounting post:
- Loosen the post retention xxxx on the pillar and insert the stainless steel tube and switch control box into the pillar. Fasten with the retention xxxx to secure in place.
3. Mount the fan motor assembly:
- Unscrew the 3 screws on the motor support collar and position the fan motor assembly onto the post protruding from the switch control box. Tighten the 3 screws to secure the fan motor assembly.
4. Fit the rear safety grille:
- Unscrew and remove the 4 grille retaining screws from the fan motor head assembly.
- Position the rear safety grille on the fan motor head and align the holes on the grille with the xxxx holes on the fan motor head. Secure the grille with the 4 screws.
5. Fit the fan blade:
- Position the blade onto the motor shaft and secure it by tightening the blade retention xxxx .
6. Fit the misting plate to the front safety grille:
- Unscrew and remove the 4 retaining screws from the mist plate assembly.
- Position the mist plate onto the front safety grille and secure it with 4 screws. Tighten the screws.
7. Fit the front safety grille/mist plate assembly to the rear safety grille:
- Unhinge the grille retaining clips from around the front safety grille parameter.
- Clip the retaining bracket over the rear grille and hinge the retaining clips to the closed position to capture the rim of the rear safety grille with the hinge clips until all closed.
- Finally, secure the grille into place with the safety xxxx and nut on the bottom of the grille assembly.
8. Fit the water tank to the cart:
- Fix the water tank on the cart shelf with the nominated screws and nuts.
- Secure the tank to the cart shelf with 4 x M8 washers and M8 x 10mm screws. Tighten them with a spanner.
- Position the fan assembly upright.
Please refer to the instruction manual for visual illustrations and additional details on the assembly process.
Add New Comment